Mazda bulletin SA-014-26
Mazda filed this with NHTSA as a service bulletin dated Mar 11, 2026, received Apr 2, 2026, about the engine. It names 55 model years (2018–2026). A service bulletin is not a safety recall: it is the manufacturer telling its dealers how to diagnose or repair a condition, and whether the work is paid for depends on the warranty in force. Quoting the number at a service desk can save a diagnosis.
What the bulletin says
Source: NHTSA's summary of the manufacturer's communicationThis Service Alert supersedes the previously issued SA(s) and TSB(s) listed below: The changes are noted in Red. SA-035/24 05/31/24 DESCRIPTION There is a concern that some water pumps are being replaced that are not faulty, due to signs of a very small coolant leak from the bleed hole. This Service Alert is to inform you about the water pump sealing mechanism and the criteria if replacement is necessary or not. A mechanical seal (A) is used for the water pump. This mechanical seal can seal coolant (B) by sliding a mating ring (C) against a seal ring (D). When the sliding surface temperature of the mechanical seal is more than 248 °F (120 °C) while driving, a small amount of steam (E) is leaked and bleeds through the bleeding hole (F). After drying, the steam leaves a green coolant deposit near the water pump bleed hole (F). This is a normal condition and does not require water pump replacement. The water pump should only be replaced if there is an accumulation of crystallized coolant near the bleed hole. When you encounter a water pump with coolant seepage marks, decide to replace it or not based on the following criteria using sample photos. NOTE: During the initial period of use*, the sliding surfaces of the seals may not yet be fully settled, which can temporarily increase the amount of leakage. Continued use will allow the surfaces to settle, reducing the leakage. Replacing parts that are already settled with new ones will increase the leakage again until the new parts become conditioned. Therefore, replacement should be avoided in this initial period of use. *As a guideline, this applies to vehicles with less than 1,860 miles (3000 km) of mileage.
Document filed under this number
| Document | Kind | Dated | NHTSA id | At NHTSA |
|---|---|---|---|---|
| SA-014-26 | Service bulletin | Mar 11, 2026 | 11030636 | not yet checked |
The summary is NHTSA’s abstract of the document, as filed under 49 CFR 579.5. One communication is usually filed as several documents — the bulletin, a dealer notice, an owner letter — and the number on any of them finds this page. A PDF link is shown only once NHTSA’s own server has been seen to serve that document; the rest are checked over the following nights. Quote the number at a service desk; it is what the dealer’s system is keyed on.
Model years it names
Source: as the manufacturer filed themand 15 more model years on this site.
A vehicle page’s bulletin list shows the newest few communications filed against that model year; the count there is every one.
Common questions
Source: NHTSA, 49 CFR 579.5Is Mazda SA-014-26 a recall?
No. A service bulletin is a manufacturer communication filed with NHTSA under 49 CFR 579.5; a safety recall carries an NHTSA campaign number (two digits, a letter, six digits) and a federal duty to repair for free. Check the vehicle’s recalls by VIN at nhtsa.gov/recalls, or on its page here.
Is the SA-014-26 repair free?
Not automatically. A service bulletin describes how to diagnose or repair a condition; who pays depends on the warranty in force, any extension, and the dealer. Quoting the number can save a diagnosis either way.
Which vehicles does SA-014-26 cover?
The manufacturer filed it against 55 model years: 2021 Mazda CX-3, 2020 Mazda CX-3, 2019 Mazda CX-3, 2018 Mazda CX-3, 2026 Mazda CX-30, 2025 Mazda CX-30 and more. Whether one particular vehicle is affected is a matter of its VIN and its build, not its model year alone.