⌘K
HomeRecallsInvestigations EA19001
NHTSA defect investigation · Engineering Analysis

Toyota, Honda and 9 others engineering analysis EA19001

Electrical overstress. NHTSA’s Office of Defects Investigation opened this engineering analysis about the air bag/restraint control module on 176 model years (2009–2019). Opened Apr 19, 2019, closed Sep 19, 2024 after 5.4 years. It led to safety recall 20V024000. became a recall

What NHTSA says

Source: Office of Defects Investigation, as filed

The Office of Defects Investigation (ODI) opened this investigation to determine if the failure of airbags to deploy during severe crashes, in certain vehicles, was the result of a safety related defect.  During the investigation a complex failure was studied that can result in non-deployment of subject vehicle air bags and other restraint system devices in severe crash events. The subject vehicles may be equipped with an airbag control unit (ACU) for the supplemental restraint system (SRS) Electronic Control Unit (ECU) manufactured by ZF-TRW.  The ECU receives signals from crash sensors mounted in the vehicle and deploys the vehicle air bags and seat belt pretensioners in accordance with manufacturer design specifications.  The ECU in the subject vehicles contains a model DS84 application-specific integrated circuit (ASIC) which controls the communication of the crash sensor signal, firing commands (i.e., when to deploy the airbag(s) and/or pretensioners), and fault information (e.g., diagnostic trouble codes). In September 2016, FCA announced recall 16V-668 for certain model year (MY) 2010 to 2014 Chrysler, Dodge and Jeep products manufactured with the subject ZF-TRW ACU.  In this recall, FCA discussed an EOS condition that resulted in a failure of the subject DS84 ASIC, which caused air bag non-deployment.  FCA noted that the defect condition had only been observed in vehicles equipped with sensor harnessing routed across the front of the vehicle.  Other FCA vehicles that also used the subject ACU, but were not equipped with cross-car harnessing, had not experienced EOS failures, despite similar time in service. During the course of this investigation, ODI sent two separate Information Request (IR) letters to six vehicle manufactures (including FCA, Hyundai, Honda, Kia, Mitsubishi, and Toyota) and one IR letter to ZF-TRW.  These IR letters resulted in ODI receiving comprehensive data from these manufacturers and suppliers. Studies of this data found that the DS84 ASIC does not have sufficient protection against negative electrical transients or electrical overstress (“EOS�) that can be generated in certain severe crashes.  An electrical transient occurs when the electrical power supplied to a circuit changes momentarily over a short duration of time.   In these severe crash cases, the crash sensors and other powered wiring can be damaged and short circuited so as to create a negative electrical transient of sufficient intensity and duration (that are outside the vehicle manufacturer's specification) to damage the ASIC before the restraint device deployment signal is received by the SRS ECU.  This damaged signal can lead to incomplete or nondeployment of the air bags and/or pretensioners.  Airbag non-deployment and/or lack of pretensioner operation can increase the risk or severity of injury in a crash. A total of 8 fatalities and 14 injuries were associated with known EOS events. The common element in all investigated manufacturers vehicles is the SRS ECU containing a DS84 ASIC manufactured by ZF-TRW.  The risk associated with the ASIC is equally shared among all OEMS involved in the investigation.  The actual real-world risk can be mitigated by other factors which were assessed by ODI during this investigation. The first mitigating factor involves protections built into the ACU design which protect the DS84 ASIC from damage.  There are multiple strategies and levels of protection employed by different OEMs that provide effective EOS mitigation.  The two most common strategies at the ACU level are circuit protection diodes on the remote senor signal lines, and current limiting resistors that protect critical components. The second mitigating factor is found at the vehicle level and involves the location and routing of the wires leading from the crash sensors to the SRS ECU.  If the wires are well protected in a crash and are not routed with other power wires carrying large currents, the risk for an EOS event is significantly reduced or eliminated. These design specific factors combine to produce a spectrum of risk for the vehicles equipped with ACUs using the DS84 ASIC.  Given the many of years of field exposure, it is possible to divide the subject population into two groups; vehicles which have experienced EOS events, and vehicles which have not experienced EOS field events. Four of the six OEMs involved in this investigation have experienced EOS field events on at least one of their models equipped with a DS84 ASIC.  All vehicle models (including the Toyota models identified in the Failure Report Summary of the opening resume for this investigation) with field events have been recalled.  In an abundance of caution, ODI kept this investigation open five years to monitor field performance and did not identify any field events on vehicles not included in existing safety recalls. Given the spectrum of risk identified in this investigation and that all vehicles with a demonstrated unreasonable risk have been recalled, ODI is closing this investigation. ODI is closing this investigation with the following manufacturer safety recalls: 16V-668, 18E-043, 18V-137, 18V-363, and 20V-024.  With the recall actions taken by the subject vehicle and equipment manufacturers, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exists on other model or model year vehicles outside of the recall scopes. The agency reserves the right to take further action if warranted by the circumstances.

Stage Engineering Analysis — NHTSA works to complete one within eighteen months Opened Apr 19, 2019 Closed Sep 19, 2024 Manufacturer Honda (American Honda Motor Co.) Components Air Bags › Air Bag/Restraint Control Module Resulting recall 20V024000

A Engineering Analysis is the deeper stage, usually upgraded from a Preliminary Evaluation: NHTSA tests, requests engineering documents and decides whether a safety defect exists. The summary is the agency’s own text from its investigation file, unedited; the opening and closing resumes with the full reasoning are on NHTSA’s site under this number.

What this means for an owner

Source: and what happens next

An investigation is not a finding that a defect exists, and it puts no duty on anyone. NHTSA opens a Preliminary Evaluation when complaints and other reports suggest a condition worth asking the manufacturer about; it upgrades to an Engineering Analysis when the answers warrant testing; it closes either when it recommends a recall, when the manufacturer recalls on its own, or when no defect trend is found. The agency’s own goals are about four months for a petition, eight for a Preliminary Evaluation or a Recall Query and eighteen for an Engineering Analysis; many run longer.

This one became a recall. The campaign page carries the manufacturer’s filed defect, risk and remedy, the build window and every model year covered; whether one specific vehicle is included is settled by VIN at nhtsa.gov/recalls.

Model years it names

Source: as NHTSA filed them

and 5 more on this site: 2018 Toyota Tacoma, 2017 Toyota Tacoma, 2016 Toyota Tacoma, 2017 Toyota Tundra, 2016 Toyota Tundra.

Also named on model years this site has no page for: 2014 Acura RLX; 2015 Acura RLX; 2014 Acura RLX Hybrid; 2015 Acura RLX Hybrid; 2012 Acura TL; 2013 Acura TL; 2014 Acura TL; 2015 Acura TLX; 2012 Acura TSX; 2013 Acura TSX; 2014 Acura TSX; 2012 Acura TSX Sport Wagon; 2013 Acura TSX Sport Wagon; 2014 Acura TSX Sport Wagon; 2010 Dodge Nitro; 2011 Dodge Nitro; 2010 Dodge RAM 1500; 2011 Dodge RAM 1500; 2012 Dodge RAM 1500; 2010 Dodge RAM 2500; 2011 Dodge RAM 2500; 2012 Dodge RAM 2500; 2010 Dodge RAM 3500; 2011 Dodge RAM 3500; 2012 Dodge RAM 3500; 2011 Dodge RAM 4500; 2012 Dodge RAM 4500; 2011 Dodge RAM 5500; 2012 Dodge RAM 5500; 2012 Fiat 500; 2013 Fiat 500; 2014 Fiat 500; 2015 Fiat 500; 2013 Honda Accord; 2014 Honda Accord; 2015 Honda Accord; 2012 Honda CR-V; 2013 Honda CR-V; 2014 Honda CR-V; 2015 Honda CR-V; 2012 Honda Civic; 2013 Honda Civic; 2014 Honda Civic; 2015 Honda Civic; 2012 Honda Civic GX; 2013 Honda Civic GX; 2014 Honda Civic GX; 2015 Honda Civic GX; 2013 Honda Civic Hybrid; 2014 Honda Civic Hybrid; 2015 Honda Civic Hybrid; 2012 Honda Civic SI; 2013 Honda Civic SI; 2014 Honda Civic SI; 2015 Honda Civic SI; 2012 Honda FIT; 2013 Honda FIT; 2014 Honda FIT; 2015 Honda FIT; 2013 Honda FIT EV and 71 more.

A vehicle page’s investigation list carries the same action; a name here is the scope NHTSA opened, not a list of affected VINs.

Common questions

Source: NHTSA Office of Defects Investigation

Is EA19001 a recall?

No — it is the investigation that led to one. Recall 20V024000 is the campaign; its page carries the remedy.

Is EA19001 still open?

No. It closed on Sep 19, 2024 and led to recall 20V024000.

Which vehicles does EA19001 cover?

NHTSA opened it on 176 model years: 2019 Acura RLX, 2018 Acura RLX, 2017 Acura RLX, 2016 Acura RLX, 2017 Acura TLX, 2016 Acura TLX and more. That is the scope of the inquiry, not a list of affected vehicles; a recall, if one follows, defines its own population by VIN.