⌘K
HomeRecallsInvestigations EA20003
NHTSA defect investigation · Engineering Analysis

Tesla engineering analysis EA20003

Loss of rearview camera. NHTSA’s Office of Defects Investigation opened this engineering analysis about the camera on 10 model years (2012–2018). Opened Nov 12, 2020, closed May 2, 2024 after 3.5 years. It led to safety recall 21V035000. became a recall

What NHTSA says

Source: Office of Defects Investigation, as filed

On November 20, 2020, the Office of Defects Investigation (ODI) opened Engineering Analysis (EA) 20-003 to investigate incidents of media control unit (MCU) failures resulting in loss of rearview camera in model year (MY) 2012-18 Tesla Model S and model year (MY) 2016-2018 Tesla Model X vehicles equipped with the NVIDIA Tegra 3 processor with an integrated 8GB eMMC NAND flash memory device. During its investigation, ODI learned that the expected usage life rating for the 8GB eMMC NAND flash memory device is approximately 3,000 “P/E� or Program-Erase cycles, after which the eMMC NAND flash memory device would become fully consumed and no longer be operational, leading to a failure of the media control unit (MCU). At a daily cycle usage rate of 1.4 per block, accumulation of 3,000 P/E cycles would take only 5-6 years. Historically, the expected life of a vehicle generally far exceeds 5-6 years of service. ODI believes that a 5- or 6-year life expectancy for a component integral to providing the driver with safety functions is insufficient. During our review of the data, Tesla provided confirmation that all units will inevitably fail given the memory device’s finite storage capacity. Tesla provided its own statistical model showing the number of projected weekly MCU repairs from 2020 to 2028, estimating that replacement rates for MCU failures will peak in early 2022 and gradually decline until (near) full part turnover has been accomplished in 2028. According to Tesla, for subject vehicles equipped with the NVIDIA Tegra 3 processor with an integrated 8GB eMMC NAND flash memory device, the eMMC NAND cell hardware will fail when reaching lifetime wear, for which the eMMC controller has no available memory blocks necessary to recover. With this failure mode, the only recovery available is a replacement of the eMMC device, achieved by physical part replacement of either the MCU assembly or visual control module subcomponent. Tesla provided information concerning the effects of MCU failure on vehicle function, which include in loss of rearview/backup camera and loss of HVAC (defogging and defrosting) setting controls (if the HVAC status was OFF status prior to failure). The failure also affects the Autopilot advanced driver assistance system (ADAS) and turn signal functionality due to the possible loss of audible chimes, driver sensing, and alerts associated with these vehicle functions. Based on this analysis, ODI issued a Recall Request Letter (RRL) on January 13, 2021. The RRL was based on ODI’s tentative conclusion that a defect related to motor vehicle safety exists in the subject vehicles because the eMMC NAND flash devices have a finite lifespan based upon the number of program/erase (P/E) cycles, after which the MCU fails due to memory wear-out, which constitutes a premature failure of safety-critical part. Tesla responded to the Recall Request Letter (RRL) on January 27, 2021, and disputed the tentative findings of the RRL. Nevertheless, on January 29, 2021, Tesla filed a safety recall (21V-035), recalling (MY) 2012-2018 Tesla Model S and (MY) 2016-2018 Model X vehicles with a center display equipped with a NVIDIA Tegra 3 processor and an 8GB eMMC NAND flash memory device. In this recall, Tesla is providing a free hardware remedy in addition to the over-the-air (“OTA�) firmware updates that the company had previously implemented. NHTSA will continue to monitor the issue as part of its ordinary processes for overseeing the effectiveness of recalls. However, based on available information, at this time, Tesla’s recall appears to address the unreasonable risk to motor safety presented by the premature failure of the component. Accordingly, the investigation is closed. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.

Stage Engineering Analysis — NHTSA works to complete one within eighteen months Opened Nov 12, 2020 Closed May 2, 2024 Manufacturer Tesla, Inc. Components Back Over Prevention › Sensing System › Camera, Electrical System › Adas, Exterior Lighting › Turn Signal, Visibility › Defroster/Defogger/Hvac System Resulting recall 21V035000

A Engineering Analysis is the deeper stage, usually upgraded from a Preliminary Evaluation: NHTSA tests, requests engineering documents and decides whether a safety defect exists. The summary is the agency’s own text from its investigation file, unedited; the opening and closing resumes with the full reasoning are on NHTSA’s site under this number.

What this means for an owner

Source: and what happens next

An investigation is not a finding that a defect exists, and it puts no duty on anyone. NHTSA opens a Preliminary Evaluation when complaints and other reports suggest a condition worth asking the manufacturer about; it upgrades to an Engineering Analysis when the answers warrant testing; it closes either when it recommends a recall, when the manufacturer recalls on its own, or when no defect trend is found. The agency’s own goals are about four months for a petition, eight for a Preliminary Evaluation or a Recall Query and eighteen for an Engineering Analysis; many run longer.

This one became a recall. The campaign page carries the manufacturer’s filed defect, risk and remedy, the build window and every model year covered; whether one specific vehicle is included is settled by VIN at nhtsa.gov/recalls.

Model years it names

Source: as NHTSA filed them

Also named on model years this site has no page for: 2012 Tesla Model S; 2013 Tesla Model S; 2014 Tesla Model S; 2015 Tesla Model S.

A vehicle page’s investigation list carries the same action; a name here is the scope NHTSA opened, not a list of affected VINs.

Common questions

Source: NHTSA Office of Defects Investigation

Is EA20003 a recall?

No — it is the investigation that led to one. Recall 21V035000 is the campaign; its page carries the remedy.

Is EA20003 still open?

No. It closed on May 2, 2024 and led to recall 21V035000.

Which vehicles does EA20003 cover?

NHTSA opened it on 10 model years: 2018 Tesla Model S, 2017 Tesla Model S, 2016 Tesla Model S, 2018 Tesla Model X, 2017 Tesla Model X, 2016 Tesla Model X and more. That is the scope of the inquiry, not a list of affected vehicles; a recall, if one follows, defines its own population by VIN.