P249E
0 owner reports and 14 manufacturer filings across 4 model years from Chevrolet, GMC.
Where P249E shows up
Source: NHTSA manufacturer communications and complaints| Model year | Filed under | Bulletins | Owner reports |
|---|---|---|---|
| 2020 Chevrolet Silverado 2500HD | Electrical System | 6 | — |
| 2020 GMC Sierra 2500HD | Power Train | 6 | — |
| 2018 Chevrolet Express | Electrical System | 1 | — |
| 2018 GMC Savana | Electrical System | 1 | — |
A model year appears here because the code is named in its record, not because every one of these vehicles sets it. Counts are mentions in the federal files, not failure rates — nobody publishes the denominator.
What it gets filed under
Manufacturer filings that name it
Source: NHTSA manufacturer communicationsService bulletins and campaigns whose filed summary names P249E. Quoting the document number at a service desk is often the fastest route to a diagnosis someone has already written down.
- PIP5664B2019-09-27 · Electrical System
- This Preliminary information communicates to the dealer technician to check for any new ECM calibration updates for DTCs P129F P16F3 P20EE P20FF P226D P249D P249E P11CC and / or P11D5 set.
- PIP5664A2019-09-03 · Equipment — Electrical
- This Preliminary information communicates to the dealer technician the procedures for DTC P11CC, P11D5, P226D, P249E, P249D, P20EE or P226D while engineering is investigating.Â
- PIP56642019-08-01 · Electrical System
- This Preliminary information communicates to the dealer technician the procedures for DTC P11CC, P226D, P249E, P249D, P20EE or P226D while engineering is investigating.Â
- 17-NA-2192017-10-01 · Electrical System — Wiring
- Diagnostic Tip for Malfunction Indicator Lamp (MIL) Illuminated - DTC P249D, P249E, U029D, U029E Set Some customers may comment that the MIL is illuminated. The technician may find one or more of the following DTCs set: U029D U029E P249D P249E Note: The graphic above depicts an example of a torn and missing seal. Moisture intrusion past a damaged (1) seal located in the connect
What P249E means
Source: SAE J2012 / OBD-IIP249E sits in the generic range of the OBD-II standard, so it means the same thing on every vehicle sold in the United States — but WhichTrim does not carry a definition for it and will not invent one. What is on this page is the record: who named it and on what.
A stored code names the test that failed, never the part that caused it. It is the starting point of a diagnosis, not its conclusion — the same code has several possible causes and the cheap one is not always right.
Common questions about P249E
Source: NHTSA files and the OBD-II standardCan I keep driving with P249E stored?
Nobody can answer that from the code alone, and a site that does is guessing. A steady light generally means the fault was logged and the vehicle is in a reduced-risk mode; a flashing light means stop soon, because a misfiring engine can destroy a catalytic converter in minutes. The safe read of this page is the mileage and the components, not permission.
Does a code mean the car is recalled?
No. Recalls are filed by campaign and matched by VIN, and none of them are triggered by a scan tool. If you want to know whether an open recall applies to one specific vehicle, check the VIN at nhtsa.gov/recalls — that is the only source that settles it.
Why do the counts here differ from other sites?
Because these are not estimates. Every number on this page is a count of documents in NHTSA's own files: manufacturer communications that name the code in their filed summary, and owner complaints that name it in the narrative. We do not model, weight or extrapolate them.
Will clearing the code fix it?
Clearing turns the light off and erases the freeze-frame data a technician would have used to work out what happened. If the condition is still there the code returns, usually within a few drive cycles, and the diagnosis now starts from less information than before.