⌘K
HomeRecalls 26V533000
NHTSA campaign 26V533000

2025–2026 Horton Critical Care Transport and 2 other Horton models: equipment recall

A loss of exterior lights can reduce the visibility of the vehicle to other drivers, increasing the risk of a crash. Inoperative equipment can delay emergency response, increasing the risk of injury.

critical 545 vehicles affected

What was reported

Source: manufacturer filing, 49 CFR Part 573
Problem Halcore Group, Inc. (Halcore) is recalling certain 2025-2026 Horton Type I, Type III, and Critical Care ambulances. The touchscreen display may stop responding to touch commands or fail to power on, preventing the activation of exterior emergency lights, as well as fire fighting and other emergency equipment. Risk A loss of exterior lights can reduce the visibility of the vehicle to other drivers, increasing the risk of a crash. Inoperative equipment can delay emergency response, increasing the risk of injury. Fix Weldon Division of Akron will update the firmware and repair the power line, free of charge. Owner notification letters are expected to be mailed October 5, 2026. Owners may contact Weldon customer service at 1-800-228-1161 or Halcore customer service at 1-800-447-0343.

Reported to NHTSA Aug 14, 2026 by Halcore Group, Inc.

Which vehicles are covered

Source: NHTSA campaign 26V533000
Model yearOn WhichTrim
2025 Horton Critical Care Transport
2026 Horton Critical Care Transport
2025 Horton Type I
2026 Horton Type I
2025 Horton Type III
2026 Horton Type III

None of the vehicles this campaign names has a page on WhichTrim: the catalogue covers the cars, trucks and SUVs the EPA certifies from 2016 on, and these vehicles fall outside it — older model years, or motorhomes, trailers, buses, motorcycles and chassis cabs the EPA does not rate. The campaign record above is complete as filed, and whether one specific vehicle is included is settled by its VIN. Other campaigns on vehicles without a page here →

The federal paperwork

Source: nhtsa.gov

Filed documents

  • Defect report PDF — The manufacturer's own filing to NHTSA describing the defect, the risk and the affected build range.

Check one specific vehicle

A recall applies to a build range, so year, make and model cannot settle it. NHTSA checks a VIN against the manufacturer's own list and tells you whether the repair is still outstanding on that vehicle.

NHTSA VIN recall lookup →

Campaign 26V533000

Own one, or run a fleet? Recall Watch checks each VIN against every new NHTSA campaign and emails you when one lands, this one's expansions included. Or take a free one-line alert by model year.

Advertisement

Common questions

Source: NHTSA, 49 CFR Part 573

Does this recall repair cost anything?

No. Federal law requires the manufacturer to remedy a safety defect or a compliance failure at no charge, for vehicles up to 15 years old measured from the date of first sale. A dealer that asks you to pay for a recall repair is in the wrong.

How do I know whether my vehicle is included?

By VIN, not by model year. The manufacturer files a build range with NHTSA and only vehicles inside it are covered, so two identical-looking cars from the same year can differ. NHTSA's own lookup checks a VIN against the manufacturer's list.

What if the repair is not available yet?

It happens, and often. Manufacturers must notify owners when a defect is found even if the parts or the software are not ready, then notify them a second time once the remedy exists. The remedy filed for this campaign is described above.

What did the manufacturer say was wrong?

The problem, risk and fix quoted on this page are the manufacturer's own words as filed with NHTSA under 49 CFR Part 573. WhichTrim does not paraphrase them.

Who started this recall?

NHTSA's record credits NHTSA's Office of Defects Investigation. A recall can begin with the manufacturer's own testing, with a defect investigation, or with a compliance test against a Federal Motor Vehicle Safety Standard.