⌘K
HomeRecalls 26V408000
NHTSA campaign 26V408000 · manufacturer recall F1035

2026–2027 Thomas Built Buses SAF-T-Liner HDX2: electrical system recall

A door that fails to open or close increases the risk of injury to occupants in a crash.

high 37 vehicles affected

What was reported

Source: manufacturer filing, 49 CFR Part 573
Problem Daimler Trucks North America, LLC (DTNA) is recalling certain 2026-2027 Thomas Built SAF-T-LINER HDX2 transit buses. The entrance door may fail to open or close when the switch is activated. Risk A door that fails to open or close increases the risk of injury to occupants in a crash. Fix Dealers will replace the door relay for the entrance door system, free of charge. Interim notification letters, notifying owners of the safety risk, were mailed August 25, 2026. Additional letters will be sent once the final remedy is available, anticipated October 2026. Owners may contact DTNA customer service at 1-800-574-0712. DTNA's number for this recall is F1035.

Reported to NHTSA Jun 26, 2026 by Daimler Trucks North America, LLC.

Which vehicles are covered

Source: NHTSA campaign 26V408000

Vehicles built from Jul 10, 2025 onward — a VIN outside that window is not part of this campaign even if the year, make and model match.

Model yearOn WhichTrim
2026 Thomas Built Buses SAF-T-Liner HDX2
2027 Thomas Built Buses SAF-T-Liner HDX2

None of the vehicles this campaign names has a page on WhichTrim: the catalogue covers the cars, trucks and SUVs the EPA certifies from 2016 on, and these vehicles fall outside it — older model years, or motorhomes, trailers, buses, motorcycles and chassis cabs the EPA does not rate. The campaign record above is complete as filed, and whether one specific vehicle is included is settled by its VIN. Other campaigns on vehicles without a page here →

The federal paperwork

Source: nhtsa.gov

Filed documents

  • Defect report PDF — The manufacturer's own filing to NHTSA describing the defect, the risk and the affected build range.

Check one specific vehicle

A recall applies to a build range, so year, make and model cannot settle it. NHTSA checks a VIN against the manufacturer's own list and tells you whether the repair is still outstanding on that vehicle.

NHTSA VIN recall lookup →

Campaign 26V408000 · the manufacturer calls it F1035

Own one, or run a fleet? Recall Watch checks each VIN against every new NHTSA campaign and emails you when one lands, this one's expansions included. Or take a free one-line alert by model year.

Advertisement

Common questions

Source: NHTSA, 49 CFR Part 573

Is F1035 the same recall as 26V408000?

Yes. F1035 is the number Daimler Trucks North America, LLC uses for this campaign in its own paperwork and in the letter it sends owners. 26V408000 is the number NHTSA files it under. One recall, two references — dealers and service departments generally quote the manufacturer's.

Does this recall repair cost anything?

No. Federal law requires the manufacturer to remedy a safety defect or a compliance failure at no charge, for vehicles up to 15 years old measured from the date of first sale. A dealer that asks you to pay for a recall repair is in the wrong.

How do I know whether my vehicle is included?

By VIN, not by model year. This campaign covers vehicles built from Jul 10, 2025 onward. The manufacturer files a build range with NHTSA and only vehicles inside it are covered, so two identical-looking cars from the same year can differ. NHTSA's own lookup checks a VIN against the manufacturer's list.

What if the repair is not available yet?

It happens, and often. Manufacturers must notify owners when a defect is found even if the parts or the software are not ready, then notify them a second time once the remedy exists. The remedy filed for this campaign is described above.

What did the manufacturer say was wrong?

The problem, risk and fix quoted on this page are the manufacturer's own words as filed with NHTSA under 49 CFR Part 573. WhichTrim does not paraphrase them.

Who started this recall?

NHTSA's record credits the manufacturer. A recall can begin with the manufacturer's own testing, with a defect investigation, or with a compliance test against a Federal Motor Vehicle Safety Standard.