⌘K
HomeRecalls 23V703000
NHTSA campaign 23V703000 · manufacturer recall SN723

2021–2023 Terex TL48: equipment recall

An aerial device that falls increases the risk of injury.

moderate 17 vehicles affected 100% reported repaired

What was reported

Source: manufacturer filing, 49 CFR Part 573
Problem Terex South Dakota, Inc. (Terex) is recalling certain 2021-2023 TL48 trucks. The bolts used to mount the aerial device to the sub-base may not be tightened properly, which could result in bolt failure, allowing the aerial device to fall. Risk An aerial device that falls increases the risk of injury. Fix Dealers will replace the mounting bolts and washers, free of charge. Owner notification letters were mailed November 17, 2023. Owners may contact Terex customer service at 1-605-882-4000. Terex's number for this recall is SN723.

Reported to NHTSA Oct 19, 2023 by Terex South Dakota, Inc, owners notified Nov 17, 2023.

Which vehicles are covered

Source: NHTSA campaign 23V703000
Model yearOn WhichTrim
2021 Terex TL48
2022 Terex TL48
2023 Terex TL48

None of the vehicles this campaign names has a page on WhichTrim: the catalogue covers the cars, trucks and SUVs the EPA certifies from 2016 on, and these vehicles fall outside it — older model years, or motorhomes, trailers, buses, motorcycles and chassis cabs the EPA does not rate. The campaign record above is complete as filed, and whether one specific vehicle is included is settled by its VIN. Other campaigns on vehicles without a page here →

How much of it has been fixed

Source: manufacturer quarterly report, 49 CFR 573.7
Reported repaired 100%

of the campaign

The final figure: the six quarters of reporting that 49 cfr 573.7 requires have closed.

This is the manufacturer's own cumulative count of vehicles it has inspected and repaired, divided by the vehicles the campaign covers. It files that count with NHTSA every quarter for six consecutive quarters, starting from the quarter in which owners were told a remedy was ready, and then the obligation ends — so a figure on an older campaign is where the count stopped, not where it stands today.

It rarely reaches 100%, and not because the work was not done. The same report asks manufacturers to count vehicles they could not reach at all — exported, stolen, scrapped, or simply never located — and those stay in the denominator. A low number means a lot of these vehicles are still out there unrepaired; it does not tell you which ones.

The federal paperwork

Source: nhtsa.gov

Filed documents

Check one specific vehicle

A recall applies to a build range, so year, make and model cannot settle it. NHTSA checks a VIN against the manufacturer's own list and tells you whether the repair is still outstanding on that vehicle.

NHTSA VIN recall lookup →

Campaign 23V703000 · the manufacturer calls it SN723

Own one, or run a fleet? Recall Watch checks each VIN against every new NHTSA campaign and emails you when one lands, this one's expansions included. Or take a free one-line alert by model year.

Advertisement

Common questions

Source: NHTSA, 49 CFR Part 573

Is SN723 the same recall as 23V703000?

Yes. SN723 is the number Terex South Dakota, Inc uses for this campaign in its own paperwork and in the letter it sends owners. 23V703000 is the number NHTSA files it under. One recall, two references — dealers and service departments generally quote the manufacturer's.

Does this recall repair cost anything?

No. Federal law requires the manufacturer to remedy a safety defect or a compliance failure at no charge, for vehicles up to 15 years old measured from the date of first sale. A dealer that asks you to pay for a recall repair is in the wrong.

How do I know whether my vehicle is included?

By VIN, not by model year. The manufacturer files a build range with NHTSA and only vehicles inside it are covered, so two identical-looking cars from the same year can differ. NHTSA's own lookup checks a VIN against the manufacturer's list.

What if the repair is not available yet?

It happens, and often. Manufacturers must notify owners when a defect is found even if the parts or the software are not ready, then notify them a second time once the remedy exists. The remedy filed for this campaign is described above.

What did the manufacturer say was wrong?

The problem, risk and fix quoted on this page are the manufacturer's own words as filed with NHTSA under 49 CFR Part 573. WhichTrim does not paraphrase them.

Who started this recall?

NHTSA's record credits the manufacturer. A recall can begin with the manufacturer's own testing, with a defect investigation, or with a compliance test against a Federal Motor Vehicle Safety Standard.