⌘K
HomeRecalls 16V455000
NHTSA campaign 16V455000

2014–2016 Itasca and Winnebago: vehicle speed control recall

A sudden loss of an engine brake without warning on a motorhome may lead to a reduced brake ability, potentially increasing the risk of a crash.

high 705 vehicles affected

What was reported

Source: manufacturer filing, 49 CFR Part 573
Problem Winnebago Industries, Inc. (Winnebago) is recalling certain model year 2014-2016 Winnebago Tour motorhomes manufactured May 25, 2013, to November 25, 2015, and Itasca Ellipse motorhomes manufactured May 25, 2013, to November 18, 2015. The throttle pedal position sensor on the affected vehicles may not return to zero, causing the engine brake to suddenly not activate as expected, reducing the vehicle's deceleration ability. Risk A sudden loss of an engine brake without warning on a motorhome may lead to a reduced brake ability, potentially increasing the risk of a crash. Fix Daimler Trucks North America has notified owners, and dealers, will replace the throttle pedal, free of charge. An interim notification was distributed to owners on July 8, 2016. The recall began on August 15, 2016. Owners may contact Daimler Warranty Campaign Department at 1-800-547-0712 or email DTNA. Warranty. Campaigns@Daimler.com.

Reported to NHTSA Jun 22, 2016 by Winnebago Industries, Inc, owners notified Aug 15, 2016.

Which vehicles are covered

Source: NHTSA campaign 16V455000

Vehicles built May 25, 2013 to Nov 25, 2015 — a VIN outside that window is not part of this campaign even if the year, make and model match.

Model yearOn WhichTrim
2014 Itasca Elipse
2015 Itasca Elipse
2016 Itasca Elipse
2014 Winnebago Tour
2015 Winnebago Tour
2016 Winnebago Tour

None of the vehicles this campaign names has a page on WhichTrim: the catalogue covers the cars, trucks and SUVs the EPA certifies from 2016 on, and these vehicles fall outside it — older model years, or motorhomes, trailers, buses, motorcycles and chassis cabs the EPA does not rate. The campaign record above is complete as filed, and whether one specific vehicle is included is settled by its VIN. Other campaigns on vehicles without a page here →

The federal paperwork

Source: nhtsa.gov

Filed documents

NHTSA has not published the scanned filings for this campaign, or has not published them yet. The campaign record itself is on their site.

Check one specific vehicle

A recall applies to a build range, so year, make and model cannot settle it. NHTSA checks a VIN against the manufacturer's own list and tells you whether the repair is still outstanding on that vehicle.

NHTSA VIN recall lookup →

Campaign 16V455000

Own one, or run a fleet? Recall Watch checks each VIN against every new NHTSA campaign and emails you when one lands, this one's expansions included. Or take a free one-line alert by model year.

Advertisement

Common questions

Source: NHTSA, 49 CFR Part 573

Does this recall repair cost anything?

No. Federal law requires the manufacturer to remedy a safety defect or a compliance failure at no charge, for vehicles up to 15 years old measured from the date of first sale. A dealer that asks you to pay for a recall repair is in the wrong.

How do I know whether my vehicle is included?

By VIN, not by model year. This campaign covers vehicles built May 25, 2013 to Nov 25, 2015. The manufacturer files a build range with NHTSA and only vehicles inside it are covered, so two identical-looking cars from the same year can differ. NHTSA's own lookup checks a VIN against the manufacturer's list.

What if the repair is not available yet?

It happens, and often. Manufacturers must notify owners when a defect is found even if the parts or the software are not ready, then notify them a second time once the remedy exists. The remedy filed for this campaign is described above.

What did the manufacturer say was wrong?

The problem, risk and fix quoted on this page are the manufacturer's own words as filed with NHTSA under 49 CFR Part 573. WhichTrim does not paraphrase them.

Who started this recall?

NHTSA's record credits the manufacturer. A recall can begin with the manufacturer's own testing, with a defect investigation, or with a compliance test against a Federal Motor Vehicle Safety Standard.