RVI preliminary evaluation PE23009
Device can break causing tire to deflate without notification to the operator. NHTSA’s Office of Defects Investigation opened this preliminary evaluation about the pressure monitoring and regulating systems. Opened May 26, 2023, closed Dec 13, 2024 after 19 months without a recall. closed
What NHTSA says
Source: Office of Defects Investigation, as filedOn June 8, 2023, Office of Defects Investigation (ODI) opened Preliminary Evaluation PE23009 to investigate reports of air pressure loss from tires equipped with Danko Manufacturing/RViBrake’s (RViBrake) Tire Patrol device, an aftermarket tire pressure monitoring system. ODI’s initial inquiry determined that RViBrake was aware of 408 sensors being returned under warranty for leaking pressure, including approximately 40 that were reported to have broken in half, leaving the tires’ valve stem core pressed open and leaking air. ODI sent an Information Request (IR) letter to RViBrake on June 8, 2023. By analyzing the IR Response data, ODI learned that the bulk of the sensors returned under warranty were for dead sensors, or minor but consistent air leaks. The manufacturer believes that many of the warranty claims are user-induced, such as damage from curb strikes or from car washes. However, 41 warranty claims were for lost upper sensor halves, a condition that can cause the tire to deflate, without notification to the operator. This condition is particularly concerning when it occurs to one of the vehicle’s steer axle tires. No crashes or injuries are known to be directly attributable to any of these sensors. RViBrake explained that in the event of a sensor half detachment, the operator would not immediately be warned. The system refreshes the tire pressure information every three minutes, but it is not uncommon for a packet of information to not be received due to interference, especially with the rear wheels, which may be further away from the receiver. If the system does not receive fresh information from the sensor three times in a row, the icon for that sensor becomes greyed out on the display screen. Furthermore, if the system does not receive information from the sensor five times in a row, an audible alert sounds to warn the operator. As part of the IR response, RViBrake supplied a video replicating the worst case scenario.In the video, a broken and separated sensor half was installed on a fully pressurized steer tire on a Class-A motorhome.The tire deflated by approximately twenty seven percent in ten minutes. With the majority of the air still remaining in the tire after ten minutes, it is believed that the vehicle could still be safely maneuvered off of the roadway, illustrating that a broken Tire Patrol sensor does not lead to an immediate or rapid air loss of the tire. After discussions with RViBrake to discuss ways to reduce the risk to operators, the company has pushed out a system software update that now triggers the audible alert after a loss of signal from the front tires in less than nine minutes. Due to the amount of time needed for a tire to deflate after a full sensor half detachment and in view of this software update action taken by RViBrake, which provides improved notification to the driver of a slow loss of pressure in the tire, ODI has closed this Preliminary Evaluation. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI report cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.
A Preliminary Evaluation is the first formal stage: NHTSA has decided the complaints and other information it screened are worth a closer look, and asks the manufacturer for its own data on the condition. The summary is the agency’s own text from its investigation file, unedited; the opening and closing resumes with the full reasoning are on NHTSA’s site under this number.
What this means for an owner
Source: and what happens nextAn investigation is not a finding that a defect exists, and it puts no duty on anyone. NHTSA opens a Preliminary Evaluation when complaints and other reports suggest a condition worth asking the manufacturer about; it upgrades to an Engineering Analysis when the answers warrant testing; it closes either when it recommends a recall, when the manufacturer recalls on its own, or when no defect trend is found. The agency’s own goals are about four months for a petition, eight for a Preliminary Evaluation or a Recall Query and eighteen for an Engineering Analysis; many run longer.
This one closed without a recall. That means NHTSA found no defect trend it chose to act on at the time, or the manufacturer addressed the condition another way (a service campaign or a bulletin, which have their own pages). A closed file can be reopened if new reports arrive.
Model years it names
Source: as NHTSA filed themNHTSA filed this action against RViBrake without naming a model year — an equipment or manufacturer-level query.
Common questions
Source: NHTSA Office of Defects InvestigationIs PE23009 a recall?
No. A preliminary evaluation is NHTSA asking questions, not a recall. A safety recall carries an NHTSA campaign number and a duty to repair for free; this one closed without one. Whether one particular vehicle has an open recall is a VIN question at nhtsa.gov/recalls.
Is PE23009 still open?
No. It closed on Dec 13, 2024 without a recall.
Which vehicles does PE23009 cover?
NHTSA filed it against RViBrake without naming a model year.